Tom Wood's Custom Driveshaft Super-Flex 1310 U-Joint
Allows For 40 Degrees Of Flex Without Binding
Until now, if you needed to run a higher angle in your drive
shaft than conventional parts would allow, the only choice was to use Toyota
mini-truck components. These were basic light weight parts designed for 1/4 &
1/2 ton vehicles and would not stand up to the demands of to days high
horsepower rock crawlers.
The unique design of off-set trunnions sets the mating yokes
further apart than a more conventional joint. This allows for 10 degrees more
flexibility than would be otherwise obtainable. While 10 degrees may not sound
like a lot, with a 30" drive shaft, this will allow more than 5" of additional
droop at your axle prior to binding of the universal joint. Our testing shows
that installing this universal joint into standard yokes, the drive shaft will
flex to 40 degrees. With a little grind work on the yokes the drive shaft will
flex to 45 degrees.
The "Super-Flex" universal joint was not designed to be a
"cure all", but rather specifically to solve a binding problem that one may
incur under situations such as full axle droop and spring wrap. Situations like
a front drive shaft, where you have a lot of lift and have also installed buggy
springs or revolver shackles in conjunction with your shackle reversal.
This u-joint does cause some vibration problems. Not intended for High Speed Applications!This
is due to the introduction of the 3rd plane of operation, which will cause the
drive shaft to run eccentric. The amount of eccentricity is a function of how
steep the drive shaft runs to begin with. Of course if you do not have good
drive shaft geometry your drive shaft it will vibrate anyway. This would be a
torsional vibration or the building and releasing of torque 2 times per
revolution on the drive shaft.
Part Number: SF-1310
Manufacturer: Tom Wood's Custom Driveshaft
Fits Vehicle: Universal